Search

How To Make a Newspaper Pot Holder - The New York Times

laingali.blogspot.com

Once the paper is hot off the presses, use it to cool down your pots.

Most people are doing a lot of cooking at home right now. These short cold days are the ideal time to enjoy steaming soup, warm roasted veggies and toasty bowls of comforting pasta. Newspaper is a good insulator, so why not turn it into a useful item that will protect your table from scorching dishes? (The reader Rhonda Fadum from Boulder, Colo., suggested this idea for a newspaper craft activity.)

Making these easy trivets is not only a fun activity for the afternoon, but it will also provide a tablescape conversation starter for months to come. Try the square version shown below, or get creative and make your own design.

Materials

  • Nine single pages of newspaper

  • Scissors

  • Bamboo skewer

  • White glue

  • Thin kitchen twine

  • Sewing needle with a large eye

Tony Cenicola/The New York Times

Step 1

Roll a full page of newspaper diagonally around a bamboo skewer from one corner to the other creating a long tube.

Tony Cenicola/The New York Times

Step 2

When almost finished rolling the tube, line the remaining paper with white glue and continue rolling until there is no excess paper. Wipe off any extra glue and remove the bamboo skewer. Repeat 8 more times so you have nine tubes.

Tony Cenicola/The New York Times

Step 3

Working with one tube at a time, roll one end tightly until it’s about the size of a dime. Keep rolling the tube, but begin forming 90-degree angles at the corners to create a rectangle.

Tony Cenicola/The New York Times

Step 4

Continue wrapping the tube tightly, squeezing into a rectangle as you go. Place glue on the end of the tube and wrap the rest of the way around, holding for a few seconds until it’s secure. Set aside to dry.

Tony Cenicola/The New York Times

Step 5

Repeat with the other tubes, creating nine rectangular newspaper pods.

Tony Cenicola/The New York Times

Step 6

Cut off approximately 18 inches of twine and thread your needle. Start with two pods; beginning underneath one pod and leaving an eight inch tail of twine, bring your needle up between the second and third rows from the outside.

Tony Cenicola/The New York Times

Step 7

Bring the needle down through the same spot in the second pod. Gently pull the thread to tighten and repeat the stitch a second time to secure.

Tony Cenicola/The New York Times

Step 8

With the bottom of the pods facing up, twist the thread once and turn it perpendicular to your previous stitch.

Tony Cenicola/The New York Times

Step 9

Wrap both strings around the front and then to the back again, much like you’d wrap a present with a ribbon. Tie a double knot and trim any excess string.

Tony Cenicola/The New York Times

Step 10

Use the same process to attach a third pod. This is one row of the trivet.

Tony Cenicola/The New York Times

Step 11

Repeat until you have three rows with three pods each.

Tony Cenicola/The New York Times

Step 12

Secure the three rows together with the same stitch and wrap technique. Now you’re ready for a hot pot.

Tony Cenicola/The New York Times

Let's block ads! (Why?)



"how" - Google News
February 21, 2021 at 10:00AM
https://ift.tt/37AVcuJ

How To Make a Newspaper Pot Holder - The New York Times
"how" - Google News
https://ift.tt/2MfXd3I
https://ift.tt/3d8uZUG

Bagikan Berita Ini

0 Response to "How To Make a Newspaper Pot Holder - The New York Times"

Post a Comment

Powered by Blogger.